Thinklogical ImageEvolution X3 Manual Bedienungsanleitung PDF herunterladen (Seite 10)

Revision D 10 June 2011

4. Installation

Image Evolution Setup:

1. In the case of a single link SDI or HD-SDI, or dual link HD-SDI source, coax

cable(s) may be connected between the Image Evolution’s Link1 IN (or in the case of

dual link, Link1 and Link2 IN), and an HD-SDI source. If desired, coax cables may

be connected between the Link1 (or Link1 and Link2) LOOP BACK BNC connectors

and a suitable monitor (or monitors). Loop back outputs will provide a raw or

unprocessed output of the video input on LINK1 IN or LINK2 IN.

2. If single or dual link HD-SDI is the desired output, connect coax cables between

the BNC connector(s) LINK1 OUT (or LINK1and LINK2 OUT) and a suitable monitor

(or monitors). LINK1 OUT and LINK2 OUT provide processed output of the video

input.

3. Connect CAT-5 cable between the RJ-45 on the Image Evolution and 10/100

Ethernet port if a network is available. (Available in future firmware updates)

4. The USB on the Image Evolution need not be connected at this point. Note:

When performing a firmware upgrade it is recommended that the IEX3 be restored

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 42 43

Keine Kommentare

Thinklogical ImageEvolution X3 Manual Bedienungsanleitung Seite 10